Picture 1：Melamine molding machine with the lowering of hydraulic press

• Before operation, connect the power supply and check whether the motor rotation direction is correct.
• Turn the machine under Manual Mode; slowly raise the machine to the position of Picture 2. 2-1 are the nuts of the tension column. Install the nuts in the position as shown in the picture. Then lock the screws 2-2.
• 
  
• Picture 2                                                                                        Picture3
• 
  
• Picture 4                                                                                        Picture 5
• The four parallel guides must be fitted with nuts, as shown in Picture 3. Then lower the machine to lower the nut to the position, as shown in Picture 4.
• After the operation, lock the nuts, as shown in Picture 5, and then tighten the nuts counterclockwise with a hammer.
• 
  
• Picture 6                                                                                             Picture 6-1
• 
  
• Picture 6-2
• Correct the parallelism of the heating plate:

1. Turn the nuts of the upper bolster high, as shown in Picture 6-1

2. Continue to raise the heating plate up, raise the upper bolster to separate it from the nut 2, but not touching the nut, as shown in Picture 6-2

3. اقلب الصامولة 1 والصمولة 2 بإحكام بإحكام إلى المسند العلوي. اضغط على الآلة حتى 230 كجم / سم 2 ، وشد الصمولة 2 عكس اتجاه عقارب الساعة